Tsd Automatic Plastic Sheet Bending Machine

• Product Type: PP Board
• Board Layers: Single Plate
• Screw No.: Single-screw
• Automation: Automatic
• Computerized: Computerized
• Certification: CE, ISO9001:2008
• Model NO.: TSD
• Customized: Customized
• Condition: New
• Transport Package: Wooden Box
• Specification: 4000mm
• Trademark: TSD
• Origin: Qingdao, China
• HS Code: 85158000
• Production Capacity: 20sets/Month

Product Description

TSD Automatic Plastic Sheet Bending Machine


 

Parameters

Model	TSD-ZW3000	TSD-ZW4000
Processing thickness(mm)	25-30	25-30
Processing length(mm)	3000	4000
Bending angle(°)	0-100	0-100
Roll circle diameter min(mm)	500	500
Air pressure(kg.f/cm2)	4-10	4-10
The rated voltage(V)	380	380
Bending heating power	9kw	12kw
Welding heating power	6kw	8kw
Drum institutions motor power	1.5kw	1.5kw
Length*Width*Height(mm)	3950*1100*1100	5000*1100*1200
Control system: Press-button control or touch screen control elected.
Material of heater:imported aluminum heater, teflon coated.
Suitable for material:PP, PE, HDPE, PVDF, PVC, PPN
Application: Plating equipment, environmental equipment, chemical containers, sewage treating pipe, ventilation systems and so on.

TSD Plastic bending function operation 

1. Knife adjustment: adjust the adjusting screw fixed at both ends of the layer plate to level the gap between the upper  knife and the lower knife, gap is 3 mm or so normally.
 
2. The angle adjustment of the flap : adjust the magnetic switch of cylinder to make a right angel.

Operation Steps:
 
A. The using temperature of the upper knife is 175 degrees , the using temperature of the lower knife is about 120 degrees.
 
B. Start the machine after heating for about half an hour.
 
C. Firstly, press the Clamping-up switch,then put in the plastic board and certain the size, press the clamping-down switch to let down the clamping piece. Secondly, press the Layer-forth switch to make the upper knife reach the location where it's going to be folded.Thirdly, press the Knife-close switch to descend the upper knife and lifting the lower knife. No sooner than the contacting part of the plastic board and the upper knife has been melted about 1/2 to 3/4 ,press the Knife- separation switch.
 
At last, press the Layer-back switch ,then the layer board will be back and the turning board will be up. When the angle is formed and cooled , press the Turning-down switch and the Clamping-up switch.